![]() Plug the adapter’s other end into your vehicle’s cigarette lighter or power socket. Insert the adapter’s barrel plug into the scanner’s DC 13.8V jack.Ģ. To power your scanner from a 12V power source in your vehicle, such as a cigarette-lighter socket, you need a 12V, 600 mA DC cigarettelighter adapter (not supplied), available at your local RadioShack store.ġ. When drilling holes, avoid obstructions behind the mounting surface. At the marked positions, drill holes slightly smaller than the screws. Use the supplied mounting bracket as a template to mark positions for the two mounting screws.Ģ. You can mount your scanner under or on top of the dashboard a desk, shelf, table or other flat surface, using the mounting bracket.ġ. Slide the scanner into the bracket, aligning the scanner’s side holes with the holes in the bracket,Īnd then screw the mounting knobs into the scanner. Attach the three protective rubber feet to the mounting bracket. To you use the scanner on a flat surface:ġ. Because the speaker is on the bottom of the scanner, you can use the mounting bracket to elevate your scanner off the surface for better sound. You can place your scanner on a desk, shelf, or table to use it as a base station. You can mount your triple trunking scanner in your vehicle or use it as a base station. Īppendix A: Glossary.Īppendix B: Search Banks.Īppendix C: CTCSS / DCS Codes.Īppendix D: Signal Stalker.Īppendix E: Talk Group Format.Īppendix F: Specifications. Saving a Talk Group ID.ĭeleting Talk Group IDs. Motorola Trunking Setup.īase and Offset Frequencies.ĮDACS Trunking Setup. Scanner Setup.ĭefining a Channel.Ĭopying a Frequency.ĭeleting Saved Frequencies.ĬTCSS AND DCS. Setting Up a Mobile Base.īracket Mounting.ĭashboard Installation.Ĭonnecting the Antenna.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |